Check out our Facebook Reviews
PACKAPUNCH cables are manufactured to order due to their bespoke nature, however, pre-orders are now closed. To receive notifications for when pre-orders are open again please either subscribe to our newsletter or follow us on Facebook or Twitter.
Custom made sync stripper board using LM1881 sync separator designed to retro fit into existing SCART cables or can be fitted inside of a console.
The LM1881 chip takes a "sync over composite video sync" (HSYNC+VSYNC+CVBS) and removes the composite video (CVBS) aspect of the signal, and outputs CSYNC (HSYNC+VSYNC) only which is the cleanest sync signal available when using an RGB SCART cable. This can help with removing unwanted onscreen artefacts, and also a CSYNC signal maybe needed for some monitors which only accept CSYNC. For further information on sync types please our Demystifying RGB Sync guide.
The LM1881 does introduce amplification to the CSYNC signal, therefore, the output of this device has a 470Ω resistor to lower this (R1).
Power requirements for (CSYNC) video sync separator:
Requires a EuroSCART cable which is wired for either 5 volts or 12 volts on pin number 8 of the SCART plug. This is needed to power up the LM1881 video sync separator circuit and without this required voltage you will not get a stable picture on your monitor. Please see diagram below which shows the location of pin 8 . If there is a wire attached to this pin then you should be good to go. If you are unsure whether your cable is wired correctly please contact us for assistance. All video game console RGB SCART cables from Retro Gaming Cables are compatible with the video sync separator version.
Made in Great Britain. Link for LM1881 data sheet http://www.ti.com/lit/ds/symlink/lm1881.pdf The SYNC BLASTER Printed Circuit Board Design is Copyright © of Retro Gaming Gables.
|Video and audio format|
|Sync type||The Sync Blaster can process "sync over composite video", "sync over luma" and also composite sync (CSYNC).|